Pni Legacy Comm Board Manual do Utilizador descarregar pdf (Página 39)

PNI Corporation 133 Aviation Blvd., Suite 101, Santa Rosa, CA 95403-1084 USA;, Fax: (707) 566-2261

For the most current specifications, please visit our website at: www.pnicorp.com

Page 39 of 42

UNUSED COMMANDS

The following commands are part of the CommBoard programming but are not being used by any of the

PNI products currently available for use with the CommBoard.

i? (Inclinometer Update)

Command Type: Query Command

Retrieves the inclinometer values.

Syntax:

i?<es>

Response Format: $Pn.nRn.n=<dcs><er>

Valid Values: P Pitch

R Roll

z? (Z Axis Sensor Update)

Command Type: Query Command

Retrieves only the corrected Z axis magnetometer values. The Z sensor output is not available on

all modules. Refer to the specific module data sheet for more information.

Syntax: z

?<es>

Response Format: $Zn.n*<dcs><er>

Valid Values: n.n

CommBoard

Unused Commands

1 2 ... 34 35 36 37 38 39 40 41 42

Sem comentários

Pni Legacy Comm Board Manual do Utilizador Página 39