Pni FieldForce Trax Manual do Utilizador descarregar pdf (Página 26)

PNI Sensor Corporation DOC#1016505 r06

TRAX User Manual Page 22

Settings”, and under the header are the various TRAX Studio tabs, which are discussed in the

subsequent sections. The header is the same regardless of which tab is selected.

To connect, set the “Serial” field to the appropriate COM port. To determine this, in

Windows right click on “My Computer”, select “Manage”, then select “Device Manager”.

Expand “Ports” and note the port for “USB Serial Port”. This should be the assigned COM

port for the TRAX.

Set the baud rate. The default is 38400, and this should be the setting the first time the

TRAX is used. Once a connection has been established, the desired baud rate can be

changed on the Configuration Tab, as discussed in Section 6.4.1.

Click the <Connect> button. When the connection is established, the light to the left of

“Status” will turn green, “Status” will change to “Connected @ [the baud rate]”, the

<Connect> button will now say <Disconnect>, the <Power Down> button will be live, and

the “Device Information” section of the header will populate.

6.3 TRAX Studio Footer and Saving/Applying Settings

Below is a picture of the TRAX Studio footer. The footer includes 4 buttons which are

discussed below. The footer is the same regardless of which tab is selected. Note that if a

field is changed on any of the TRAX Studio tabs, then either <Apply> or <Save> must be

selected for the change to take effect.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 61 62

Sem comentários

Pni FieldForce Trax Manual do Utilizador Página 26