Pni CompassPoint Prime Manual do Utilizador descarregar pdf (Página 12)

PNI Sensor Corporation DOC# 1014177 r08

Prime User Manual – July 2011 Page 6

4 Set-Up

This section describes how to configure the Prime in your host system. To install the Prime into

your system, follow these steps:

Make electrical connections to the Prime.

Evaluate the Prime using the included StudioPrime program or terminal emulation

software, such as Tera Term or RealTerm, to ensure the compass generally works

correctly.

Choose a mounting location in the host system.

Mechanically mount the Prime in the host system.

Perform a field calibration.

4.1 Electrical Connections

The Prime incorporates both a 16 pin ribbon connector (topside of PCB) and a 9 pin Molex

connector (bottom side of PCB) for connecting the unit to the user’s system. The user should

decide which connector they want to use, and only use this connector. The Prime will not

function properly if commands are sent on both connectors. The pin-out for both connectors

is given below in Table 4-1. Pin #1 for both connectors is indicated in Figure 3-1.

Table 4-1: Prime Pin Descriptions

Pin #

16 pin Ribbon

Connector

9 pin Molex

Connector

PNI Cable

Wire Color

GND

Black

Gray

GND

Green

~CS

Orange

GND

Violet

Brown

GND

RS232 TxD

Yellow

RS232 RxD

Blue

GND

+5 VDC

Red

GND

RS232 RxD

GND

RS232 TxD

GND

+5 VDC

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 68 69

Comentários a estes Manuais

Sem comentários

Pni CompassPoint Prime Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Pni CompassPoint Prime